Aug 4, 2021
Plasticulture strawberry planting, fall growth considerations shared

Early to mid-September is the optimum period for planting strawberries in the plasticulture system on Delmarva. Most strawberry varieties should be planted by the third week in September for best spring yields.

The Delmarva Peninsula, or simply Delmarva, is a large peninsula on the East Coast of the United States, occupied by the vast majority of the state of Delaware and parts of the Eastern Shore regions of Maryland and Virginia.

Strawberry establishment in the plastic bed takes 3-4 weeks. During establishment, the goal is to have plants root as quickly as possible in the soil and start to send out new growth. This requires attention at planting. Most Delmarva growers are using plugs. Plant so that the plug is at the level of the soil or is just covered with a small amount (1/8”) of soil but avoid getting soil into the crown of the plant. Deep planting will result in reduced stands and weak plants due to rotting in the crown area. Shallow planting (where part of the plug is out of the ground) will result in plugs desiccating and reduced stands. Soil should be firm around the plug and water provided at planting. It is advantageous to overhead irrigate several times, even with water provided by drip lines, to reduce plant shock. It is also hard to wet beds completely with the drip system in sandy soils thus affecting establishment.

Rooting also requires adequate bed soil temperature. Raise high beds, the higher the better to allow for good drainage. Lay plastic making sure there is a firm crowned bed. The goal is to have the plastic tight against the soil to allow for good heat transfer. Loose plastic will have poor heat transfer and can reduce fall growth. Beds with depressions that allow water to accumulate can lead to disease problems in strawberries.

The goal coming out of the establishment period is to have 3 or more fully green leaves on the plant. After establishment, plants will send out new growth and develop branch crowns during October and November. The goal by late fall is to have 2-3 branch crowns form from the mother plant. Crown growth occurs when temperatures are above 50°F. Flower buds are also initiated during this time. Often, growers receive plugs or plants later than September 20. For later plantings, low tunnels offer an opportunity to maintain temperatures above 50°F for a longer period achieving this goal. Early row covers may also be used to achieve this goal – research has shown that early row covers may not increase crown number but can increase flower bud initiation in the fall. While planting too late can reduce spring yields, planting too early risks too many crowns being developed, especially in Chandler, leading to smaller unmarketable. That is why we don’t plant in late August on Delmarva

Plant size in the fall is also critical for high yields the following spring. Plants should be about 8 inches in diameter going into winter. Sugars produced in leaves are translocated into the crowns of the plant where they are converted into starch for winter storage. This starch is then used in the spring at green-up.  Inadequate starch storage will also lead to lower yields in the spring. Plants should also go into winter with enough leaves to help insulate the crown.

– Gordon Johnson, Extension Vegetable & Fruit Specialist, University of Delaware

 




Current Issue

On-farm AI: Water, farm, labor research guide decisions

Data collection tool expands farm management

Carmel Valley winegrapes: Parsonage Village Vineyard

IFTA Yakima Valley tour provides orchard insights

IFTA recognizes tree fruit honorees

Pennsylvania recognizes fruit industry professionals

Fresh Views 40 Under 40

see all current issue »

Be sure to check out our other specialty agriculture brands

produceprocessingsm Organic Grower